Ready or Not (PS5 Remote Play)
Q and E lean left and right on the two stick clicks the game puts lean on, Home and Caps Lock both toggle low ready so the left hand has a key it can actually reach, X changes fire mode, T toggles the laser and light and N is night vision. G is the equipment button that opens the item wheel when held, Z and middle mouse both reach the command button for a default order or, held, the command wheel, F interacts and yells for compliance, R reloads and checks the magazine when held, and Ctrl crouches and melees on a hold the way the console layout folds bash onto crouch. The stick ramps in over 50 ms rather than snapping to full deflection, so a slow deliberate peek is possible, Shift drops it to a quiet walk, and Tab opens the tablet on the touchpad.
From the author
Setting this up for PS5 Remote Play
This preset drives a virtual DualShock 4 from your keyboard and mouse, so Ready or Not reads an ordinary controller. Buttons, sticks and triggers are proven end to end through chiaki-ng on a real PS5. The touchpad binds are here because the output IS a DualShock 4, but a touchpad press arriving over Remote Play has not been measured yet, so treat those binds as untested.
Install a Remote Play client on this PC and pair it with your PS5. These presets are built and tested against chiaki-ng.
In the Remote Play client, turn OFF its own keyboard and controller mapping, and unplug or hide any controller you are not using. The client merges every input it can see with this one, so anything left connected fights your binds.
In OmniControl, set the Emulation output to DualShock 4 and start it.
Import this pack, then turn on Drive a Controller.
Start the Remote Play client and connect. It picks up the virtual DualShock 4 the same way it would a real pad plugged into this PC.
Launch Ready or Not on the console and play.
Aim is tuned to 40 cm per 360. If that feels fast or slow for your mouse, change it on the Drive a Controller page - everything else in the preset stays as it is.
If the character drifts or walks by itself, a real controller is still connected and the client is merging it with this one. OmniControl's Hide my controller fixes that, or unplug it.
Remote Play streams video, so there is always some delay between your hand and the screen. A wired connection to the console does more for that than any setting here.
What this pack changes
- Lightbar - custom colour
- Emulation - virtual controller target
Have the app installed? Use Open in OmniControl below - it jumps straight to the import preview. Otherwise:
- Open OmniControl and go to Profiles (or Game Packs).
- Click Import, then paste the code above into the share-code box.
- Preview what it changes, then create a profile from it.
Importing only ever creates a NEW profile - your existing profiles are never touched.