Tom Clancy's The Division 2 (PS5 Remote Play)
E and Q throw skill one and skill two on the two bumpers the game puts them on, G is the grenade and holds for grenade types, V is the armor kit and holds for consumables, X melees and middle mouse marks a target. Space takes cover, holds to change cover and double taps to roll, while Ctrl vaults and climbs, which the pad keeps on its own separate button, and 1 to 3 all cycle the weapon because the pad has a single swap button rather than three slots. The left stick ramps in over about 70 ms so a tap of A or D slides you along cover instead of popping you out of it, aim is 38 cm per 360 and drops to 0.6 in the over the shoulder aim state, and M opens the map on the touchpad.
From the author
Setting this up for PS5 Remote Play
This preset drives a virtual DualShock 4 from your keyboard and mouse, so Tom Clancy's The Division 2 reads an ordinary controller. Buttons, sticks and triggers are proven end to end through chiaki-ng on a real PS5. The touchpad binds are here because the output IS a DualShock 4, but a touchpad press arriving over Remote Play has not been measured yet, so treat those binds as untested.
Install a Remote Play client on this PC and pair it with your PS5. These presets are built and tested against chiaki-ng.
In the Remote Play client, turn OFF its own keyboard and controller mapping, and unplug or hide any controller you are not using. The client merges every input it can see with this one, so anything left connected fights your binds.
In OmniControl, set the Emulation output to DualShock 4 and start it.
Import this pack, then turn on Drive a Controller.
Start the Remote Play client and connect. It picks up the virtual DualShock 4 the same way it would a real pad plugged into this PC.
Launch Tom Clancy's The Division 2 on the console and play.
Aim is tuned to 38 cm per 360. If that feels fast or slow for your mouse, change it on the Drive a Controller page - everything else in the preset stays as it is.
If the character drifts or walks by itself, a real controller is still connected and the client is merging it with this one. OmniControl's Hide my controller fixes that, or unplug it.
Remote Play streams video, so there is always some delay between your hand and the screen. A wired connection to the console does more for that than any setting here.
What this pack changes
- Lightbar - custom colour
- Emulation - virtual controller target
Have the app installed? Use Open in OmniControl below - it jumps straight to the import preview. Otherwise:
- Open OmniControl and go to Profiles (or Game Packs).
- Click Import, then paste the code above into the share-code box.
- Preview what it changes, then create a profile from it.
Importing only ever creates a NEW profile - your existing profiles are never touched.